Work environment：Double Head-Precision Grinder Model DMSQ-S

一、Double Head-Precision Grinder Model DMSQ-S Working conditions

Supply voltage:AC, Rated voltage of 380 (1 ± 10%) V
Area:Equipment Dimensions, Around leave 1m,the top leave 2m
Foundation:Ground should be solid and reliable,The flat concrete floor is best.
                  We recommend the bottom of the device fixed with cement after adjusting the machine balance.
Air temperature:5℃～55℃
Relative Humidity:≤90％
Environmental conditions:There should be no air pollutants (such as acids, corrosive gases, salts objects)

二、Double Head-Precision Grinder Model DMSQ-S

Double Head-Precision Grinder Model DMSQ-S Take FCL Packing,According to the center of gravity and weight lifting when the method for determining.When out of the box,open the cover first and then forced open the side.Rolling mat in the bottom of the fuselage with something when handing.Please pay attention to safety when lifting.

Machine should be installed on a solid concrete floor,Pouring concrete cement according to "foundation plan".After ement aging,please adjust the machine.Otherwise, the machine easily deformed and ccelerated wear of the machine.Thereby reducing the life of the machine.

Installation location:Please select no shock, vibration and small temperature changes and safe place.According to the geological conditions determine the depth of the foundation when installing the foundation.Build the foundation according to the following diagram.And allow installation of the footnote hole.To wipe the flat above.You can install after the concrete solidified.

Foundation plan

Installation Steps:
（1）Put in place the horn,put the bolts into the foundation hole.After the machine hanging in place,put the bolt into bolt hole at the appropriate height,screw on the nuts and put on the Plate.Alignment position to take down the fixtures and clean the machine.
（2） With the level meter to adjust the machine and the level should be placed on the rail.
（3） Straighten anchor bolts,Pouring of concrete to the hole.
（4）After Solidified,adjust tooling accuracy,To the horizontal deviation is less than 0.05/1000mm,fastening bolt and the machine on the ground surrounded by a smooth cement.
（5）Please connect ground wire and connect the power supply electrical schematic.
（6）Polishing wax should be applied to the polishing wheel when polishing.To improve the quality and brightness of the polished.

Special Note:
Tian Ming will try to provide you with the standard, comprehensive information, but information may be errors or omissions.
Product images are for reference only, please sell the real product.
Above are subject to change without notice.

Related links:
Double Head-Precision Grinder Model DMSQ-S：Introduction
Double Head-Precision Grinder Model DMSQ-S：Photo
Double Head-Precision Grinder Model DMSQ-S：Video
Double Head-Precision Grinder Model DMSQ-S：Work environment
Double Head-Precision Grinder Model DMSQ-S：FOB
More Information Grinder